 |
Whisper's design accomplishes these major tasks:
- No Serving Required!
- Damps unwanted string vibration
- Reduces noise
- Increased arrow speed
- Eliminates movement on the bowstring
- The oval shaped hole increases light transmission and remains round optically at full draw
- Since it doesn't move improved accuracy and shooting consistency
- Available in 3 sizes 3/16", 7/32", 1/4".
|
|
|
|
Always use a bow press to install the “Whisper”
Not using a bowpress or some type of tension reduction device can damage the bowstring.
- Put the bow in a bow press or other tension reduction device and
compress bow.
- Separate the bowstring so that an even number of strands are on
both sides. We recommend 1 twist per 1 to 1.5 inchs of bowstring
to ensure proper installation. This will improve the locking feature of
the peep sight. [With out adequate number of twists there could be the
possibility of the peep sight coming out of the bowstring during normal
use, resulting in damage to equipment or injury.]
- Install the WHISPER peep sight between the separated strands so that
the strands run through the string channels.
- Install the tubing to the extrusion on the back of the peep sight and
then attach to the cable using a larks head knot. (If applicable).
- To adjust position of the peep after installation, compress bow again
to decrease string tension and move the peep up and down the
bowstring to desired position. Trying to move the peep up and
down the bowstring under full tension could result in damage
to the peep sight.
WARNING:
Failure to follow these instructions could lead to injury.
|
|